Aerovent IM-500 Manuel d'utilisateur

©2013 AeroventTable of ContentsUnit Information ... 1Special Precautions ...

10 Aerovent IM-500Adjustable Pilot(Aerovent Part #1192-01E)The pilot is properly adjusted at the factory; however, the conditions of

11 Aerovent IM-500flame MUST be a “clean blue flame”. A little yellow tipping is acceptable, but the flame should be blue. T

12 Aerovent IM-500outside air. When power is interrupted to the motors, the return air damper closes and the profile damper opens. Th

13 Aerovent IM-500Mild Temperature Control(Aerovent Part #1175-01E)A mild weather temperature stat is supplied with most units. The p

14 Aerovent IM-50011. Turn unit off IMMEDIATELY and check the blower for proper rotation of wheel. Correct if required by reversi

15 Aerovent IM-500NOTE: RECOMMENDED FREQUENCY OF TEST IS ONCE PER MONTH.32. Safety shut off valve leak test. Remove cap from test c

16 Aerovent IM-500Remote Switch in “Summer” PositionWith the remote switch in the “Summer” position, the fol-lowing sequence of opera

17 Aerovent IM-500If lamp #11 does not light, check:1. Is lamp #11 getting power or is the bulb defective?2. High temperature limi

18 Aerovent IM-500LUBRICATION INSTRUCTIONS FOR FANS AND BLOWERSBearings and grease lines on fans are lubricated on assembly. When lub

19 Aerovent IM-500CARE OF HEATER FOR EXTENDED SHUTDOWN PERIODSIf the unit is to be shut down for an extended period of time, the fo

2 Aerovent IM-500Recirculating UnitsBuilding ReliefAdequate building relief MUST be provided so as not to overpressureize the buildi

20 Aerovent IM-500TERMS AND CONDITIONS OF SALE1. AGREEMENT AND ACCEPTANCE. The terms and conditions set forth in this Agreement shal

21 Aerovent IM-5008. LIMITED WARRANTY AND REMEDIES. Seller warrants to the original purchaser that the products sold hereunder shall

22 Aerovent IM-500of Seller without its written consent. When Buyer orders articles Buyer is licensed to have made for Buyer, Seller

23 Aerovent IM-500Aerovent800 S. High St., Covington, OH 45318Phone: (937) 473-3788 Fax: (937) 473-3793DIRECT GAS FIRED AIR MAKE-UP

15. Gas supply to unit: Natural Propane Gas supply pressure to unit: " w.c. psig 16. Mount UV sensor on sigh

25 Aerovent IM-500 36. Mild weather control cycled and reset to proper setting (65o F) 37. Air ow proving switch cycled for func

26 Aerovent IM-500

27 Aerovent IM-500

AEROVENT | WWW.AEROVENT.COM5959 Trenton Lane N | Minneapolis, MN 55442 | Phone: 763-551-7500 | Fax: 763-551-7501 ®

3 Aerovent IM-500Special PrecautionsTHE INSTALLATION AND MAINTENANCE INSTRUCTIONS IN THIS MANUAL MUST BE FOLLOWED TO PROVIDE SAFE, EF

4 Aerovent IM-500B. All installation of this equipment must be performed by a qualified installation agency only defined in ANSI Z2

5 Aerovent IM-500Return ducts should be designed in the same manner. Where ductwork (or other enclosure) is installed to the inlet or

6 Aerovent IM-500required, as structural design of accessories will support these items. However, rails should be extended to suppor

7 Aerovent IM-50011. Purge air from gas piping before lighting unit.12. After air has been purged, check for gas leaks in the p

8 Aerovent IM-500Operation InstructionsPRIOR TO OPERATIONAlthough this unit has been assembled and test fired at the factory, the f

9 Aerovent IM-500Flame Safeguard Control(Aerovent Part #25941-01)All units are equipped with a Honeywell RM7895C flame safety relay.